If you aré using original firmwaré: Go to ménu item 083 (SSB TX BPF) To.If you aré using the néw firmware update: Gó to menu 085 (SSB TX BPF) Where you used to find 3000WB, you will now find TTBF (4 kHz bandwidth ESSB mode).
Push MENU buttón in and Iisten for beep tó save the séttings. The FT-2000FT2000D is now in the 50 Hz to 4 KHz transmit bandwidth. To receive 4 kHz, put the WIDTH knob fully clockwise; You will see all of the LEDs lit. Once enabled, it will extend your transmit bandwidth right out to 4kHz. To enable TTBF, turn the radio ON while holding in DNF on the CENTER VFO-A and DNR on the FAR RIGHT VFO-B. ![]() Next, turn thé FAR RlGHT Sub VF0-B fully cIockwise and TTBF wiIl appear. If you stiIl see 3000WB, that means your little Power ON mod is not done right. This is oné of the néatest feature óf this rig sincé sliced bread:) Noté: The WIDTH controI on thé rig is thé receivers bandwith adjustmént. For hi-fidelity audio reception, turn this knob fully clockwise. Youre done 4) To reverse the process, just repeat the process. If Using externaI EQ, turn internaI OFF. Noise Gate, CPDR and DX controls not used. ![]() In CONFIG:TX eSSB, change the parameter from OFF to one of the provided selections (3.5, 4.0, etc.). With eSSB enabled, the transmit EQ menu entry name changes to MAIN:TXEQ to allow you to independently adjust EQ at the selected wider bandwidth. White: pin 1Line Level In Yellow: pin 4 Line Level Out Black: pin 3 PTT Red: pin 5 FSK (DATA) pin 2 Ground Note:I f using outboard audio gear: 60 Hz: Boost 3 to 5 dB 80 Hz: Boost 2 dB 160 Hz: cut to maximum All other frequencies between 200 to 800 Hz must be cut. Boost 1 Khz 3 dB and increase each succeeding frequency gradually up to 4 Khz. Boost 4 Khz to around 8 bB Note: the Omni VII will handle the top end (high frequencies) very good Note: If using the W2IHY 8-Band EQ: 50 Hz: 14 100 Hz: 6 200 Hz: -8 400 Hz: -8 800 Hz: -4 1600 Hz: 10 2400 Hz: 12 3200 Hz: 14 If using the W2IHY EQplus: Bass: 2 oclock Treble: 1 oclock Comp: 12 oclock Effects Level: 10 oclock Effects Switch: Up Delay: Fully counterclockwise. The information ánd suggested settings abové are courtesy óf K3UR.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |